How to USE:
1.Select the appropriate voltage and connector for the electronic device to charge / power supply.
2.Press the switch to start charging when your device connected with EPOWER; If you unplug the
cable, auto-sleep will start in one minute.
3.Five lights will flash circularly during the charging by EPOWER and all lights will keep bright when
your device is full-charged.
4.During the charging for your device, LED lights indicate the balance power of built-in battery of
EPOWER. Four lights indicate 80% balance, 3 lights indicate 60% balance, two lights indicate 40% balance and one light
indicates 20% balance. The built-in battery is empty when all LED lights start to flash.
5.Press the switch five seconds to start If you want to use LED for illumination and select the
status ( light, strobe, SOS, close) by pressing the switch to transform.
6.Store the product in a cool and dry place and away direct sunlight.
To avoid cause accidents, make sure note the following cautions:
1. Take off the main unit within 30 seconds after starting the car.
2. Don't clip the two terminals at the same end on the battery.
3. Don't Disassemble the unit!
Car, mobile phone, PSP, MP3/MP4/MP5,Tablet PC, PDA,Camera etc.
1: Car emergency start charging(Only works for gasoline Car 12V,
Have been tested, this jump starter can start 5.0 liter gasoline engine but can't
start diesel engine)
2: Mobile phone&Digital Product Charging
1 x OSUKI Car Starter Jumper Power Bank 14000mAh (FREE Tyre Pump)